SHOW SIDEBAR
Rosineer MIGHTY-10 Quick Start Guide

1. Position your machine on a sturdy flat table surface.
2. Attach the Driptek support legs as displayed in the manual and tighten the screws.
3. Close the release valve using the jack handle.
4. Connect the press control panel to the electrical outlet using the enclosed power cord and flip the power switch.
5. Now enter your desired press parameters (temperature, time, and temperature scale) using Set, Up, and Down buttons. Please follow the press manual for detailed descriptions and visual guides. Once the parameters are saved, the plates heating starts.
6. Wait until the plates reach the set temperature.
7. Position your precursor in the center of the bottom plate.
8. Gently pump the jack handle to lift up the bottom plate and apply pressure. Use the built-in pressure gauge to monitor the rising pressure.
9. When the desired pressure is reached, start the timer countdown by pressing Timer button.
10. Grasp the press handle and tilt the machine backwards until it rests on its support legs.
11. Wait until the countdown ends and the press starts beeping.
12. Lift up the press into the vertical position and stop the timer beeping by pressing Timer button again.
13. Use the jack handle to release the bottle jack valve opening the plates.
14. Remove your pressed material using tools or heat resistant gloves.
15. Press the next batch or flip the switch to turn off and unplug it from the outlet. 

Recommended Accessories
Pre-Press Mold 3" x 5" Rectangular
Filter Bags 3" x 5" (36, 72, 90, 120 micron)
2.5" x 6.5" (36, 72, 90, 120 micron)
3" x 7" (36, 72, 90, 120 micron)
3" x 200" Filter Tube (36, 72, 90, 120 micron mesh options)
Parchment Paper 10" x 7" pre-cut, 50 sheets per set
6" x 8" PTFE sheets, 12 total
Tool set Cleaning Tool Kit
Bamboo Wax Organizer Kit
Cooling Plate 6" x 8" Cooling / Warming Plate